To maintain a proper water seal, replace the ring with an approved spare. Long-term use can result in O-ring wear.Recharge a stored battery every four months to maintain optimal battery performance. Lock the light or take out the battery to prevent accidental activation during storage or transportation.If the light will not be used for an extended period, remove the battery, or the light could be damaged by electrolyte leakage or battery explosion.Fenix recommends using an excellent quality battery.Disassembling the sealed head can cause damage to the light and will void the warranty.Usage and Maintenance of the E35 V3.0 3000 Lumen Flashlight Note: This only works with Fenix ARB-L21 Series 21700 rechargeable Li-ion battery. When this happens in Low output mode, the battery level indicator blinks red to remind you to timely recharge or replace the battery. When the voltage level drops below the preset level, the flashlight is programmed to downshift to a lower brightness level until Low output is reached. When the temperature drops below 60☌, it will then allow the user for the reselection of Turbo mode. When the light reaches a temperature of 60☌ or above, the light will automatically step down a few lumens to reduce the temperature. The light will accumulate a lot of heat when used on Turbo and High output levels for extended periods. Green light flashes: sufficient 85% - 50%.With the light switched off, single click the side switch to check the battery status, the indicator will last for 3 seconds. Unscrew the light head and insert the battery with the anode side (+) towards the light head, then screw the light head back on. Only use quality batteries with circuit protection will reduce the potential for combustion or explosion but cell damage or short circuiting are potential risks the user assumes.īattery Replacement of the E35 V3.0 3000 Lumen Flashlight * 21700 Li-ion batteries are powerful cells designed for commercial applications and must be treated with caution and handled with care. With the light switched on, press and hold the side switch for 1.2 seconds to enter Strobe, single click the side switch again to turn back to the previously used output level. *In locked status, clicking or pressing the switch will activate 2 one-second blinks on Eco to indicate locked status. Unlock: with the light locked, double click the switch within 0.5 seconds, the light will be unlocked and activated on Eco. Lock: with the light switched off, double click the switch within 0.5 seconds to lock the light, the light will blink twice on Eco to indicate locked status. With the light turned on, single click the side switch to cycle through Eco→Low→Med→High→Turbo. Solar Panel: Monocrystalline 22.7W - 5.Press and hold the 0.5 seconds to turn on/off the light. Mount on a pole and the 900 Lumen Solar LED Area Light allows you to put light where you need it without having to run electrical wires to the power grid!" Solar powered and waterproof (IP65 rated), you can set it up and forget it about it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |